Kunz MR44B Bedienungsanleitung PDF herunterladen (Seite 11)

The cutting height can be adjusted in a range from 2.0" to 8.0". This is accomplished by turning

the he

to raise ckwise to lower the mower cutting height.

llow easier pivoting. Care should be taken not to loosen too much or excess wear and

The adjustment crank may unturn due to vibration. This will allow the mower’s cutting height to

change. The crank can b ustment nut tube and the

height adjust support. See Figure 9.

Figure 9: Securing Crank While Not In Use

ight adjust crank located at the back of the mower. See Figure 8. Turn the crank clockwise

the mower cutting height and counter-clo

DANGER: Shut off tow vehicle engine and allow mower blades to stop completely before

Adj

2. The desired cutting height can be determined by measuring the distance from the ground to

is 1-5/1

Note:

t screw may be too tight. Loosen the pivot bolts slightly to

attempting to measure the cutting height.

ust the mower as follows:

Pull the mower on to a smooth, level surface.

the outside lower edge of the mower deck and adding 1-5/16”. The mower blade cutting edg

6” above the outside lower edge of the mower deck.

If the height adjust crank does not turn easily, the pivot bolts holding the carrier arm

assemblies and height adjus

flexing may occur. Greasing the threads on the height adjust screw may also allow

greater ease in adjustment.

Note: After setting the initial cutting height, quick field adjustments can be completed by

counting crank turns. Roughly 8 turns will equal 1” of vertical movement.

e secured by folding it down between the adj

Adjustment Crank

Height Adjust Support

Adjustment Nut Tube

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Keine Kommentare

Kunz MR44B Bedienungsanleitung Seite 11