Kunz MR44B Bedienungsanleitung

OWNER’S MANUALWith Assembly Instructions KUNZ ENGINEERING, INC. 42 / PH (815) 53

The tongue is equipped with a screw pin shackle clevis to provide movement in all directions on Figure 7: Rough Cut Tow Behind Towing Suggestions B

The cutting height can be adjusted in a range from 2.0" to 8.0". This is accomplished by turning the he to raise ckwise to lower the mower

C. STARTING ENGINE WARNING: Set parking brake on tow vehicle. Attach mower tongue to tow vehicle. WARNING: Do not start rough cut mower unless it

WARNING: Remove all objects from the work area that might be picked up and thrown by ty shields and deflectors in place during operation. t Dry gra

F. DRIVE B Refer to Figure 10 : Shut off engine and allow mower blades to stop turning before making any Remove the safety shields. Loosen the nuts

With the clutch engaged, adjust the nuts on the spring-loaded idler adjuster bolt until the length ofthe spring is approximately 2-3/4”. This is the

No r CAUTION: If brake stud is not set in correct position, under-braking or over-braking may ossible fire could occur due to excessive friction and

ACREASE ROUGH CUT MOWER SPECIFICATIONS Model ModelMR44BMR44KENGINE:Engine Make Briggs & Stratton Kohler Command ProEngine Model Intek AVS OHV CV

ACREASE ROUGH CUT MOWER PARTS LIST Item Part # Description Quantity1 214021 Cup Washer 62 216002 Wire Lock Pin, .31" x 2.50" 23 216009 Screw

18 Item Part # Description Quantity31 600253 Safety Belting 132 600254 Battery Box Spacer 233 600264 Belt Sheild, Left 134 600265 Belt Sheild, Right

SAFETY INTRODUCTION Your safety, and the safety of others, is very important. To help you make informed decisions about safety, we have provided ope

UACREASE 44” ROUGH CUT MOWER PARTS 50 2 3 4 6 7 8 9 1 11 14 29 16 15 25 18 20 21 22 10 24 30 34 43 35 45 48 36 37 38 39 42 26 33 12 47 31 28 19 44 5 2

TIONAL EQUIPMENTOP OP und support in soft or water best in. round. hibious vehicles or tracked ATVs. • ore than doubles the tire surface area i

OPTIONAL EQUIPMENT OPTIONAL ELECTRIC LIFT KIT nd Shown on the 57” Rough Cut Mower Electric Lift Kit (Part # 003912) The opti

22UOPTIONAL EQUIPMENT OPTIONAL FLOATATION KIT The optional floatation kit consists of one additional front and rear tire, mounting brackets and har

IMPORTANT SAFETY INFORMATION WARNING: Do not allow anyone to operate this equipment who has not fully read and comprehended the safety manual and w

SAFETY SIGNS AND LOCATIONS Clean or Replace Any Safety Signs That Are not Readable or Damaged 275003 – Danger Dec

ASSEMBLY INSTRUCTIONS Read the complete assembly instructions before starting the assembly. You should have: - one mower deck assembly - two carrier

3. Install the two carrier arm assemblies in the pivot arms, which are located on the mower deck assembly. Place the assembly so that the castered t

bolts, lock washers and nuts holding the cross brace tubes in place. This step insures that proper alignment of the carrier arms has been achieved.

TION OF TONGUE ASSEMBLY C. INSTALLA1. he tongue can be installed either on the left or right carrier arm assembly depending on how the tow-behind m

Figure 6: ATV Tongue Assembly OPERATIONS AND ADJUSTMENTS Wire Lock Section of Wire Lock Pin (Placed Back From Direction of 5/16” Wire Direction of T